With type: WPO-ABQ, FD200, h635, q34-16 (HA633) , HA616, CM410. One, carry out seriously " v equipment is current operating rules " concerned regulation. 2, implement undermentioned concerned provision seriously: (one) make seriously before the job: 1, the examination cuts cutting tool and punching mould to answer in good condition without burst apart, tighten firm firm. 2, check the clearance between drift and modular hole wall to answer even, drift lowest position should exceed modular aperture plane slightly. (2) make seriously in the job: 1, the facility that has a variety of use, punching and cut armor plate, round steel, Fang Gang, profiled bar (wait to be the same as below like profiled bar of angle iron, channel, ┴ , I-steel) etc among them one of can undertake at the same time. But did not avoid negative charge overweight, answer to be cut respectively to armor plate, round, Fang Gang, profiled bar, forbid to cut two kinds of rolled steel inside same time. 2, cut cutting tool point to should keep sharp, point becomes blunt or have burst apart phenomenon, answer to change in time. 1, when cutting armor plate, round steel, Fang Gang, profiled bar must impaction, forbid to undertake cutting below the condition that does not have impaction. 2, forbid from go up on joy stick makings. CNC MillingCNC Machining